Pollak 6-Port Fuel Selector Valve with Switch and AUX-MAIN Legend

Pollak, 6-Port Fuel Selector Valve, With Switch and AUX-MAIN Legend

Genuine 'Stoneridge Company U.S.A.' Pollak Valves

Incorporates six ports including return ports, designed for use on dual-tank fuel systems for selecting the tank from which the fuel should be drawn from (and returned to)

These motorized valves are driven into position by an electric motor and are stable in either position. They only draw power for a fraction of a second during transfer. A switch in the valve shuts off the motor when the valve reaches the selected position, it then does the same in reverse when power supply is reversed across the terminals

Complete with Wiring Connector, Changeover Switch, AUX-MAIN Legend and Installation Manual

IMPORTANT - The pollak valve can only be used with clean fuel, that is FILTERED TO 10 MICRONS, and in a liquid state. Failure to observe these points will result in either 1. Dirt building up on the pistons, or 2. Solid (frozen) fuel preventing the piston from travelling - both will result in immediate failure of the control circuit which will burn out. Failure of this nature is outside of warranty and so must be avoided

Also available (order separately from below menu) - wiring kit bag, comprising:

2m 1mm2 Red Wire (10A fused live to switch)
2m 1mm2 Black Wire (ground to switch)
4m 1mm2 White Wire (switch to valve, the polarity of these cables reverses with operation of the switch)
1x Inline Mini Blade Fuse Holder, 1.21mm2/16AWG
1x 10 Amp Mini Blade Fuse
1x Terminal Red, Piggyback 6.3mm2
4x Terminal Red, Spade 6.3mm2
1x Terminal Blue, Piggyback 6.3mm2
2x Terminal Blue, Spade 6.3mm2
2x Terminal Connector Butt Splice, Red 1mm2
1x Tap Splice, Red 1mm2
1x Tap Splice, Blue 1mm2
1x Wiring Diagram

Specification
Pollak Part Number	42-302P
Voltage	12vDC
Current	0.5 Amps
Recommended Fuse	10 Amps
Tank to Valve Fuel Supply Tails (2)	For 3/8 Inch (10 mm) ID Hose
Valve to Engine Fuel Supply Tail (1)	For 3/8 Inch (10 mm) ID Hose
Engine to Valve Fuel Return Tail (1)	For 5/16 Inch (8 mm) ID Hose
Valve to Tank Fuel Return Tails (2)	For 5/16 Inch (8 mm) ID Hose
Mounting Holes	2x 5/16 Inch Threaded Nuts, with 1 3/16 Inch Centers
Max Pressure	65 PSI
Min Ambient Temperature	4°c
Max Ambient/Liquid Temperature	82°c
Material of Construction	Glass Reinforced Polyester

Retail Boxed Product!

Photograph below is of a fully installed and working Pollak valve

Video below is of a Typical Twin-Tank Installation

If using in a vehicle running on SVO / WVO you should also be using a Heat Exchanger to heat the fuel entering the engine, this will help to prevent pump and injector failure. Below an example of a suitable product for this application.